2018 Edge Owner Manual

Doors and Locks

Locking and Unlocking the Doors Locking All Doors Press andhold 7·8 and 9·0 simultaneously with the driver door closed. You do not need to enter the keypad code first. Unlocking the Driver Door Enter the factory-set or your personal five-digit code. You must press each number within five seconds of each other. The interior lamps illuminate. Note: All doors unlock if you enable the all-door unlockingmode. See Locking and Enter the factory-set or your personal five-digit code, then press 3·4 within five seconds. Displaying the Factory-Set Code Note: You need to have two programmed intelligent access keys for this procedure. Unlocking (page 63). Unlocking All Doors

To program additional personal entry codes, repeat steps 1 through 3, then for step 4: • Press 3·4 to save personal code 2. • Press 5·6 to save personal code 3. • Press 7·8 to save personal code 4. • Press 9·0 to save personal code 5. If your vehicle is fitted with MyFord Touch, you can also program the system with a personal entry code. See Settings (page 455). Hints: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. • The factory-set code works even if you have set your own personal code. Erasing a Personal Code 1. Enter the factory-set five-digit code. 2. Press and release 1·2 on the keypad within five seconds. 3. Press and hold 1·2 for two seconds. You must do this within five seconds of completing Step 2. All personal codes erase and only the factory-set five-digit code works. Anti-Scan Feature The keypad goes into an anti-scan mode if you enter the wrong code seven times. This mode turns off the keypad for one minute and the keypad lamp flashes. The anti-scan feature turns off after: • One minute of keypad inactivity. • You press the unlock button on the remote control. • You switch the ignition on. • You unlock your vehicle using intelligent access.

1

E195807

1. Open the floor console storage compartment lid.

68

Edge(CDQ)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201706,FirstPrinting

Made with FlippingBook flipbook maker