2018-F150-Owner's Manual

Roadside Emergencies

If your vehicle has a key system: 1. Switch off the vehicle. 2. Switch on the vehicle. 3. Repeat steps 1 and 2 to re-enable the fuel pump. If your vehicle has a push button start system: 1. Press START/STOP to switch off your vehicle. 2. Press the brake pedal and START/STOP to switch on your vehicle. 3. Remove your foot fromthe brake pedal and press START/STOP to switch off your vehicle. 4. You can attempt to start the vehicle by pressing the brake pedal and START/STOP , or press START/STOP without pressing the brake pedal. JUMPSTARTINGTHEVEHICLE WARNINGS Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery.Whenworking near the battery, always shield your face and protect your eyes. Always provide correct ventilation. Keep batteries out of reach of children. Batteries contain sulfuric acid. Avoid contact with skin, eyes or clothing. Shield your eyes when working near the battery toprotect against possible splashing of acid solution. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If acid is swallowed, call a physician immediately.

WARNINGS Use only adequately sized cables with insulated clamps.

Preparing Your Vehicle Do not attempt to push-start your automatic transmission vehicle.

Note: Attempting to push-start a vehicle with an automatic transmission may cause transmission damage. Note: Use only a 12-volt supply to start your vehicle. Note: Do not disconnect the battery of the disabled vehicle as this could damage the vehicle electrical system. Park the booster vehicle close to the hood of the disabled vehicle, making sure the two vehicles do not touch. Connecting the Jumper Cables WARNINGS Do not attach the cables to fuel lines, engine rocker covers, the intake manifold or electrical components as grounding points. Stay clear of moving parts. To avoid reverse polarity connections, make sure that you correctly identify the positive (+) and negative (-) terminals onboth thedisabledandbooster vehicles before connecting the cables. Do not attach the end of the positive cable to the studs or L-shaped eyelet located above the positive (+) terminal of your vehicle’s battery. High current may flow through and cause damage to the fuses. Do not connect the end of the second cable to the negative (-) terminal of the battery to be jumped. A spark may cause an explosion of the gases that surround the battery.

322

F-150(TFC)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201709,SecondPrinting