2018-Flex-Owner's-Manual

Seats

REAR SEATS Adjusting the Rear Seats Second RowSeats WARNINGS

Note: Adjusting any activememory feature or pressing a memory switch during a memory recall cancels the operation. Linking a PreSet Position to your Remote Control or Intelligent Access Key Fob Your vehicle can save the preset memory positions for up to two remote controls. 1. With the ignition on, move thememory features to the desired positions. 2. Press and hold the desired preset button for about five seconds. A tone sounds after about two seconds. Continue holding until you hear a second tone. 3. Within three seconds, press the lock button on the remote control you are linking. To unlink a remote control, follow the same procedure – except in step 3, press the unlock button on the remote control. Note: If more than one linked remote control or intelligent access key is in range, the memory function moves to the settings of the first key to initiate a memory recall. Easy Entry and Exit Feature This feature adjusts the position of the seat and steering column to allow easier exit and entry to the vehicle. The driver seat automatically moves 2 in (5 cm) rearward when the transmission is in park (P) and you remove the key from the ignition or you switch the ignition off. The driver seat and steering wheel return to their previous positions when you put the key in the ignition or switch the ignition on. You can enable or disable this feature through the information display. See Information Displays (page 97).

Always drive and ride with your seatback upright and the lap belt snug and low across the hips. Reclining the seatback can cause an occupant to slide under the seat's seatbelt, resulting in severe personal

injuries in the event of a crash. Recline Adjustment

E209847 Note: For the bench seat only, make sure the center seatbelt is unbuckled before folding the seatback. Lift the handle to adjust the seatback rearward or forward. You can also fold the seatback forward until it is flat.

129

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting