2018-Flex-Owner's-Manual

Seatbelts

If...

Then...

You and the front seat passenger buckle your safety belts before you switch the ignition on or less than 1–2 minutes elapse after you switch the ignition on... You or the front seat passenger do not buckle your safety belts before your vehicle reaches at least 6 mph (9.7 km/h) and 1–2 minutes elapse after you switch the ignition on... The safety belt for the driver or front passenger is unbuckled for about 1 minute while the vehicle is traveling at least 6mph (9.7 km/h) and more than 1–2 minutes elapse after you switch the ignition on... switch this feature off, the intent of the system is to remind you to wear your safety belt to improve your chance to survive an accident. We recommend you leave the system switched on for yourself and others who may use the vehicle. Note: The driver and front passenger warnings switch on and off independently. When you perform this procedure for one seating position, do not buckle the other position as this will terminate the process. Note: If you are using MyKey, you cannot disable the Belt-Minder. Also, if you have previously disabled the Belt-Minder, it will be re-enabled during the use of MyKey. See MyKey™ (page 57). . Deactivating and Activating the Belt-Minder Feature WARNING While the system allows you to

The Belt-Minder feature will not activate.

The Belt-Minder feature activates, the safety belt warning light illuminates and a warning tone sounds for 6 seconds every 25 seconds, repeating for about 5 minutes or until you and the front seat passenger buckle your safety belts. The Belt-Minder feature activates, the safety belt warning light illuminates and a warning tone sounds for 6 seconds every 25 seconds, repeating for about 5 minutes or until you and the front seat passenger buckle your safety belts. Read Steps 1–4 thoroughly before proceeding with the programming procedure. Before following the procedure, make sure that: • The parking brake is set. • The transmission is in park (P). • The ignition is off. • The driver and front passenger safety belts are unbuckled. 1. Switch the ignition on. Do not start the vehicle. 2. Wait until the safety belt warning light turns off (about 1 minute). After Step 2, wait an additional 5 seconds before proceedingwith Step 3. Once you start

Step 3, you must complete the procedure within 20 seconds.

40

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting