2018-Flex-Owner's-Manual

Keys and Remote Controls

Replacing the Battery Note: Refer to local regulations when disposing of transmitter batteries. Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board. Note: Replacing the battery does not erase the programmed key fromyour vehicle. The transmitter should operate normally. The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent. Integrated Keyhead Transmitter

4. Insert a new battery with the + facing upward. Press the battery down to make sure it is fully in the housing. 5. Reinstall the battery housing cover onto the transmitter. Intelligent Access Key 1. Remove the key blade from the transmitter.

E142432 2. Twist a thin coin under the tab hidden behind the key blade head to remove the battery cover. Do not use the key blade to remove the cover or you could damage it.

E235202 1. Twist a thin coin in the slot of the transmitter near the key ring to remove the battery cover. 2. Carefully remove the rubber gasket fromthe transmitter if it does not come off with the battery cover. 3. Remove the old battery.

E138622 3. Remove the old battery.

4. Insert a new battery with the + facing downward. Press the battery down to make sure it is fully in the housing.

E235203

54

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting