2018-Ford-Expedition-Owners-Manual

Towing

Note: Additional stickersmay be purchased through your FordDealers parts department.

Some examples of conventional type trailers are shown below. Note: You cannot use the system with the types of trailers marked with the cross. The systemonly works with conventional trailers. It does not work with other types including gooseneck and fifth wheel.

E209805 Use the supplied measurement card, a tape measure and pen to carefully mark the area where to attach the sticker (supplied in the back cover pocket of your quick start guide). Make sure the whole sticker is within the zone between the two arcs or distance markers on the diagram, and is also visible in the rear view camera display. Step 4: TakeMeasurements After the sticker is correctly placed on the trailer you must take some key measurements. Note: Accurate measurements must be taken for the system to operate properly. Note: When rounding in inches, round upward if the measured length is a quarter inch or greater. Round downward if the measured length is less than a quarter inch. For example 12.25 in (31.11 cm) would be rounded up to 12.50 in (31.75 cm). 12.13 in (30.8 cm) would be rounded down to 12.00 in (30.48 cm). Note: When rounding in centimeters, round to the nearest whole centimeter. If the measurement is less than 0.2 in (0.5 cm) round downward. If the measurement is more than 0.2 in (0.5 cm) round upward. For example, 11.9 in (30.3 cm) would be rounded down to 11.8 in (30 cm). 12.0 in (30.5 cm) would be rounded up to 12.2 in (31 cm).

E209766 Follow the information display prompts. Step 3: Place the Sticker on the Trailer Frame The supplied sticker must be placed in an area visible by the rear view camera. Note: The cargo and trailer hookup lamps turn on automatically to improve visibility. Note: An assistant can help to carry out the following procedure. Note: Make sure nothing can obstruct the rear view camera's view of the sticker. For example, items such as a jack handle or wiring. Note: Position the sticker on a flat, dry and clean horizontal surface. For best results apply the sticker when temperatures are above 32°F (0°C). Note: Do not move stickers after they are placed. Do not re-use any stickers if removed.

266

Expedition(TB8)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201707,FirstPrinting