2018-Ford-Expedition-Owners-Manual

Towing

Measurement B has reached maximum or minimum value: • Make sure that the sticker placement instruction in step 3 of the setup has been followed. Stickers placed outside the allowed zone adversely affect the system performance and could cause improper feature function. • Make sure that themeasurement being made is the horizontal distance only from center of sticker to the hitch ball center. A straight line distance that includes any vertical rise or drop increases the measurement and causes an inaccurate value to be entered into the system. See step 4 of the setup for additional measurement instructions. Measurement C has reached maximum or minimum value: • Make sure that the sticker placement instructions in step 3 of the setup have been followed. Stickers placed outside the allowed zone adversely affect the system performance and could cause improper feature function. If you have met all the criteria for sticker placement and you see this message this sticker is either too far belowor too close to the camera to properly recognize the sticker. In order for the system to operate correctly the sticker height must be lowered if you receive the minimum warning or the sticker height must be raised if you receive the maximum warning. • Only one sticker can be placed on the trailer for correct system function. The previous sticker must be removed or covered so only one sticker is visible to the camera. • Measurement B and C must be measured again if a new sticker is placed on the trailer.

Measurement D has reachedmaximum or minimum value: • Make sure that themeasurement being made is the horizontal distance only from the bumper to the center of the single axle or the center of all the axles on the trailer. See step 4 of the setup for additional measurement instructions. The TBA systemdoes not support trailer lengths outside the range allowed by the information display. System is circling something beside the sticker or system cannot find the sticker: • Make sure the rear camera is clean and the sticker is clearly visible in the camera image. Clean the camera and sticker if necessary. • The camera system uses the entered measurements to help locate the sticker. Inaccurate sticker measurements degrade the system’s ability to locate the sticker. Verify the measurements entered into the system are accurate. • Remove the incorrectly circled label or decal if possible. • If you cannot resolve the issue a new sticker location should be tried. The sticker location must still meet the requirements noted in step 3 of the setup instructions. Only one sticker can be placed on the trailer for correct system function. The previous sticker must be removed or covered so only one sticker is visible to the camera. Calibration The systemmonitors various vehicle parameters to ensure your vehicle is being driven straight and the trailer straight behind your vehicle. Any steering input or trailer movement pauses the calibration.

270

Expedition(TB8)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201707,FirstPrinting