2018-Ford-Expedition-Owners-Manual

Wheels and Tires

3. Reinstall the lug nuts until the wheel is snug against the hub. Do not fully tighten the lug nuts until thewheel has been lowered. 4. Lower the wheel by turning the jack handle counterclockwise.

1. With the vehicle on level ground, block both sides of the wheel diagonally opposite (other side and end of the vehicle) to the wheel being changed. Do not jack the vehicle on a hill or incline. 2. Obtain the spare tire and jack tools from their storage locations. 3. Use the tip of the jack handle to remove any wheel trim. 4. Loosen each wheel lug nut one-half turn counterclockwise but do not remove them until the wheel is raised off the ground. 5. Position the jack according to the jack locator arrows found on the frame and turn the jack handle and extension tool assembly clockwise. 6. Raise the vehicle to provide sufficient ground clearance when installing the spare tire, about 1/4 inch (6 millimeters). Installing the Spare Tire

1

4

3

6

5

2

E166719

5. Remove the jack and fully tighten the lug nuts in the order shown. See TechnicalSpecifications (page368). Stowing the Flat or Spare Tire 1. Lay the tire on the ground, near the rear of the vehicle, with the valve stem side facing up. 2. Slide the wheel partially under the vehicle and install the retainer through the wheel center. If equipped, you may have to remove the wheel center cap prior to pushing the retainer through the center of the wheel. To remove the center cap, press it off with the jack tool from the inner side of the wheel. Pull on the cable to align the components at the end of the cable. 3. Using the swivel wrench, insert it through the access hole behind the third row seat and engage the winch.

E175447 1. Remove the lug nuts with the lug wrench. 2. Replace the flat tire with the spare tire, making sure the valve stem is facing outward.

367

Expedition(TB8)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201707,FirstPrinting