2018-Ford-Expedition-Owners-Manual

Doors and Locks

3. Press the push button ignition switch once and wait for a few seconds. 4. Press the push button ignition switch againand remove the intelligent access key from the center console. 5. Insert the secondprogrammed key into the backup slot in the center console, then press the push button ignition switch. The factory-set code appears in the information display for a few seconds. Note: The code may not display until after any other warning messages first display.

To display the factory-set code in the information display: 1. Insert a key into the ignition and switch the ignition on for a few seconds. 2. Switch the ignition off and remove the key. 3. Insert the second key into the ignition and switch the ignition on. The factory-set code will display for a few seconds. Note: The code may not display until after any other warning messages first display. Locking and Unlocking To Unlock the Driver Door Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps illuminate. Note: All doors unlock if you disable the two-stage unlocking mode. See Locking and Unlocking (page 65). To Unlock All Doors Enter the factory-set code or your personal code, then press 3·4 within five seconds. To Lock All Doors Press and hold 7·8 and 9·0 at the same time (with the driver door closed). You do not need to enter the keypad code first. Displaying the Factory-Set Code Note: Two programmed intelligent access keys are required for this procedure. 1. Open the floor console storage compartment lid. 2. With the buttons facing the rear of your vehicle and the key ring facing upward, place the first intelligent access key into the backup slot inside the center console.

70

Expedition(TB8)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201707,FirstPrinting