2018-Ford-Expedition-Owners-Manual

Liftgate

Setting the Liftgate Open Height 1. Open the liftgate. 2. Stop the liftgatemovement by pressing the control button on the liftgatewhen it reaches the desired height. Note: Once the liftgate has stopped moving, you can also manually move it to the desired height. 3. Press and hold the liftgate control button on the liftgate until a tone sounds, indicating programming is complete. Note: You can only use the liftgate control button to program the height. Note: You cannot program the height if the liftgate position is too low. The new open liftgate height is recalled when the power liftgate is opened. To change theprogrammedheight, repeat the above procedure. Once you open the power liftgate, you can manually move it to a different height. Note: The system recalls the new programmed height, even if you disconnect the battery. When operating the power liftgate after you have programmed a lower height than fully open, you can fully open the liftgate by manually pushing it upward to the

E252965 Press and release the liftgate control button. Disabling the Liftgate Button You can disable the liftgate button under the Advanced Settings menu. See General Information (page 109). Opening the LiftgateWindow See LiftgateWindow (page 99). Stopping the LiftgateMovement Note: Do not apply sudden excessive force to the liftgate while it is in motion. This could damage the power liftgate and its components. You can stop the liftgate movement by doing any of the following: • Pressing the liftgate control button. • Pressing the liftgate button on the remote control twice. • Pressing the liftgate button on the instrument panel.

maximum open position. Obstacle Detection When Closing

The system stops when it detects an obstacle. Three tones sound and the system reverses to open. When you remove the obstacle, you can power close the liftgate.

74

Expedition(TB8)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201707,FirstPrinting