2018-Navigator-Owners-Manual

Liftgate

Note: Entering your vehicle when the liftgate is closing can cause your vehicle to bounce and activate obstacle detection. To prevent this, let the power liftgate close completely before you enter your vehicle. Before driving off, check the instrument cluster for a liftgate or door ajar message or warning indicator. Failure to do this could result in unintentionally leaving the liftgate open when driving. When Opening The system stops when it detects an obstacle and two short tones sound. Remove the obstacle to operate the liftgate. Using the Hands-Free Liftgate (If Equipped) Make sure you have an intelligent access key within 3 ft (1 m) of the liftgate. 1. Stand behind your vehicle, and face the liftgate. 2. Move your foot, in a single-kick motion, without pausing, under and away from the rear bumper detection area. 3. The liftgate power opens or closes.

You can stop the liftgate movement by doing any of the following: • Pressing the liftgate control button. • Pressing the liftgate button on the remote control twice. • Pressing the liftgate button on the instrument panel. Setting the Liftgate Open Height 1. Open the liftgate. 2. Stop the liftgate movement by pressing the control button on the liftgate when it reaches the desired height. Note: Once the liftgate has stopped moving, you can also manually move it to the desired height. 3. Press and hold the liftgate control button on the liftgate until a tone sounds, indicating programming is complete. Note: You can only use the liftgate control button to program the height. Note: You cannot program the height if the liftgate position is too low.

The new open liftgate height is recalled when the power liftgate is opened. To change the programmed height, repeat the above procedure. Once you open the power liftgate, you can manually move it to a different height. Note: The system recalls the new programmed height, even if you disconnect the battery. When operating the power liftgate after you have programmed a lower height than fully open, you can fully open the liftgate by manually pushing it upward to the maximum open position. Obstacle Detection When Closing The system stops when it detects an obstacle. Three tones sound and the system reverses to open. When you remove the obstacle, you can power close the liftgate.

83

Navigator (TB9) Canada/United States of America, enUSA, Edition date: 201708, First Printing