C318-G User manual – MEA (English UI) (update changes appli

Maintenance and self-service

Connect the positive terminal of another 12V power source to the positive jump-start point of the battery, and the negative terminal to the negative jump-start point of the discharged vehicle battery. After unlocking and powering on the vehicle, first remove the negative terminal of the 12V power supply, and then remove the positive terminal. Jacking and lifting Follow the steps below to lift the vehicle. 1. Park the vehicle in the center of the lift. 2. Position the lifting arm pad beneath the designated body lifting area, specifically between the notches on the side sill panel skirt, as depicted in the diagram. Do not position the lifting arm pad under the battery.

3. Adjust the height and position of the lifting arm pad to ensure proper placement. 4. Elevate the lift to the required height ensuring the lifting arm pads remain in the correct position. 5. Follow the lift manufacturer's instructions and engage all safety locks.

Warning! Do not lift the vehicle while the charging cable is connected.

Danger! Do not perform operations on vehicles that are not properly supported, as it may lead to safety incidents. Warning! Do not lift from beneath the battery. Only place the lifting arm pad under the designated body lifting point. The position illustrated in the diagram is the sole approved lifting point for this vehicle. Lifting at any other point may cause damage. Damage to this vehicle caused by improper lifting is not covered under the warranty. Trailer towing ※ The mounting bracket for the towing device is factory-mounted on the vehicle, located in the center of the rear bumper.

223