F-MAX-USER MANUAL-FULL BOOK-ENGLISH

MAINTENANCE AND SERVICE

Engine

it is recommended that you drive to an authorized workshop. •Lamp shall light up for 15 seconds, and dim out completely. It is recommended to you to drive to an authorized workshop in this case. • If there is no error, lamp shall not light up. Cleaning the engine: Do not apply pressurized water to the sensors and electronic control unit while you are washing the outer surface of the engine with pressurized water. Water ingress to electronic units will cause short circuits on the electrical pins, thus malfunctions on the engine. CAUTION Check the engine oil level before starting on your journey. Engine oil level is not displayed while driving.

Before going to the next phase, lamp will dim out for 5 seconds. If a malfunction is detected, lamp will show one of the 4 following behaviours till the engine start: •Lamp shall light up continuously. In this case it is recommended that you drive to an authorized workshop. •It shall light up for 3 seconds and dim out for 5 seconds. It is recommended to you to drive to an authorized workshop in this case. • Lamp shall light up 2 times in 3 seconds, and dim out for 5 seconds. It is recommended to you to drive to an authorized workshop in this case. • If there are no errors, it shall light up for 1 second and dim out for 5 seconds. After starting the engine: If there is an error, lamp will light up in 2 ways according to the error type, •Lamp shall light up continuously. In this case

Engine and drivetrain system malfunction This indicates a malfunction in the engine and/or drivetrain components. Vehicle may continue normal operation or engine may reduce the power based on the severity of the fault. Please visit the nearest Ford Trucks authorized dealership. Before starting the engine: Engine malfunction lamp of your vehicle will self check by illuminating for 5 seconds when the ignition switch is on (before engine start). This is the lamp check phase. The lamp will be dim out for 10 seconds after that. Then it will be illuminating again for 5 seconds. This is the preparation phase. If all data is ready for examination the lamp will stay illuminated for 5 seconds, if not, it will blink 5 times in 5 seconds. (This does not affect the function, and is not a sign of malfunction.) MIL (malfunction indicator lamp)

5

- 188 -