F-MAX-USER MANUAL-FULL BOOK-ENGLISH

AUXILIARY HEATER

Hydronic M-II

Mounting and fastening Fix the unit holder from the installation kit to the heater using 4 hexagon screws M8 and 4 spring washers (tightening torque 12+0.5 Nm). Fix the heater and the mounted unit holder in a suitable 5 place in the vehicle using 5 hexagon screws M8, 5 spring washers and 5 hexagon nuts M8 (tightening torque 12+0.5 Nm).

Nameplate The nameplate is on the front and the 2nd nameplate (duplicate) is fixed to the side of the control box / fan unit. If required, the installer can stick the duplicate name- plate in a clearly visible position elsewhere on the heater or near to the heater. Please note! The regulations and safety instructions to be observed for this chapter are stated on page 5.

1 Originalnameplate 2 2nd nameplate (dupliate

1 Heater 2 Heaterbracket

- 306 -