F-MAX-USER MANUAL-FULL BOOK-ENGLISH

CONTROLS AND INDICATORS

Trip Computer

You shall ensure that the tire pressure are correct even if the tire pressure low warning lamp is not lit. The tire pressure and temperature monitoring system is equipped with a system fault indicator to warn you when the system does not operate correctly. The function of the fault indicator and the tire pressure low warning lamp is common. When the system detects a malfunction, the warning lamp shall flash for approximately one minute and then remain continuously illuminated. If the malfunction is resumed, this is repeated whenever you turn the ignition on. System has detected a malfunction that requires servicing. If the fault indicator is lit, the systemmay not be able to detect or indicate a low tire pressure. Fault may be caused by many reasons such as installation of spare tires or rims that prevent the correct operation of the system. Always check for tire pressure monitoring system fault warning after replacing one or more tires or rims on your vehicle. Ensure that the spare tires or rims installed allow correct operation of the system. With Tire Pressure Monitoring System Replacement of Tires Always have your tires inspected. We recommend you to contact an authorized service station.

WARNING While the tires are inflating the system may not react immediately to the air added to the tires. Sensor Learning Operation Sensors may be used after performing a learning operation when the tires are replaced, when a new a sensor is used and/or when their position on the vehicle are changed. Select the location of the tire to be relearned after entering the TPMS “Tire Pressure Sensor Learning” under the “Maintenance” menu in the instrument panel, and keep the OK key pressed. Sensor is activated by increasing/ decreasing the air pressure of the relevant tire when the message indicating that the sensor learning operation is started is displayed. A message indicating that the operation is completely successfully is displayed on the screen. Then the new sensor is learned and its location is specified. Spare tire does not have a sensor at this moment, and the following label is attached to the tire.

3

CAUTION Note: Each road wheel and tire is installed with a tire pressure sensor inside the groove of the wheel and tire assembly. Pressure sensor is installed to the valve body. Tire covers the pressure sensor and it is not possible to see the sensor without removing the tire. Be careful to prevent damage to the sensor while replacing the tire. Understanding Tire Pressure Monitoring System Systemmeasures the pressure and temperature values on six tires at two axles and sends these values to the vehicle. System detects the low pressure as significantly lower than the correct inflation pressure and the warning lamp is illuminated. Inflate the tires to the correct pressure. An information message is displayed on the indicator when the system detects a high, low and excessively low tire pressure and a high tire temperature

- 34 -