H476-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

Shifting

Automatic and Manual Operation: Automatic: Transmission electrical control unit selects the best gear according to the engine and load status. Gear selection and shifts are performed automatically. False gear selection is not possible. Transmission shifts to most economical mode if engine brake is not activated (low engine speed) If the engine brake is activated, transmission shifts down to increase engine speed Clutch movement and shifts are performed automatically Gears may be corrected manually. False shifting is not possible. Initial operation (lifting the vehicle) Moving the Vehicle Make sure that the air is filled up adequately. You can tell whether the air is filled or not by the air pressure section of the instrument panel. Or you may wait until the driver's seat is completely filled with air. If the driver's seat is filled with air, this means that there is enough air for the transmission. AL warning shall be displayed on the screen if the air in the vehicle is inadequate.

Shift to D for moving forward

CAUTION If the vehicle is on a slope when you release the park brake, it may slip backwards or forwards if you do not press the accelerator. Keeping the vehicle uphill and slightly depressing the accelerator pedal shall cause the transmission to half clutch, the clutch shall start to slip and it shall warm up. CL shall be displayed on the screen if the clutch is overheated. If you see this warning, either press on the accelerator a little to allow the vehicle to move or press on the brake to hold the vehicle. Otherwise, clutch may burn out on early mileages. If you see the CWwarning on the screen, this means that the clutch is worn out. Vehicle shall not move in such a case. Call the authorized workshop. Using in Manoeuvre Mode The automatic transmission has manoeuvring modes to move the vehicle forward and backward precisely. When in the manoeuvre mode, the transmission does not close the clutch fully or closes the clutch in a very a long time than normal. This prevents the vehicle frommoving forward abruptly and provides driving safety in approaching manoeuvres that require precise movement

When you shift to D, the transmission shall start in automatic drive mode and shall select the starting gear itself, depending on load and inclination. D shall be displayed on the screen, indicating that the vehicle is started in automatic mode. WARNING In some cases, the transmission software may not be able to calculate the starting gear (when the vehicle is started recently, when no information received or due to calculation errors). If you think that the transmission can not select the appropriate gear according to the vehicle load and the inclination of the road, you may change the take-off gear with the + and - commands on the shift knob. (Max. 6th gear may be selected for take-off) Before moving, observe that the transmission has selected the gear on the display

4

Release the park brake and press on the accelerator slowly. Transmission shall slowly release the clutch and allow the vehicle to move.

- 108 -