H476-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

ECAS (Electronically Controlled Air Suspension)

Manual Control Unit (In Vehicles with Air Suspension )

Using Manual Control Unit (Only In Vehicles with Air Suspension)

1. Ignition switch should be in position to activate the air control system by the "manual control unit". 2. Functions desired can be performed after pressing the driven axle selection button. 3. Press the "STOP" button if you need to stop the operation during any procedure. 4. If you want to record a certain chassis height, press the "STOP+M1 or M2" buttons for 2 seconds at the same time. This would record the height to the system. In the future, when you want to adjust the vehicle to this height, press M1 or M2 button after you press the "front selection - rear axle" button.

4

Chassis height of the vehicles with 4 air bellows on rear axle may be adjusted by the control. ECAS control is placed on the left of the driver's seat over the fender. WARNING Do not change the chassis height of your vehicle by the manual control unit when driving. Use the manual control unit when your vehicle is stationary and parking brake is applied. This is important for the safety of you and your vehicle.

1- N/A 2- Rear axle activation light 3- N/A 4- Driven axle selection button 5- M1 Memory button 6- M2 Memory button 7- Normal drive height button 8- Lifting button

NOTE:

marked buttons are not active.

Symbol is illuminated on the instrument when the vehicle is not at driving height

9- Lowering button 10- Stopping button

- 119 -