H476-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

ECAS (Electronically Controlled Air Suspension)

Manual Control Unit (In Vehicles with 6 x 2 Air Suspension)

1. Ignition switch should be in position to activate the air control system by the "manual control unit". work has been performed. 2. Functions desired can be performed after pressing the driven axle selection button or lifted axle selection button. 3. Press the "STOP" button if you need to stop the operation during any procedure. 4. If you want to record a certain chassis height, press the "STOP+M1 or M2" buttons for 2 seconds at the same time. This would record the height to the system. In the future, when you want to adjust the vehicle to this height, press M1 or M2 button after you press the "front selection - rear axle" button. In the future, when you want to adjust the vehicle to this height, press M1 or M2 button after you press the "front selection - rear axle" button. WARNING Do not tamper with the rear suspension load detection sensor connections of your vehicle and do not have ECAS values changed.

4

Chassis height of the vehicles with 6x2 air suspension may be adjusted. ECAS control is placed on the left of the driver's seat.

1- N/A- This button is not active. 2- Rear axle activation light 3- N/A- This button is not active. 4- Driven axle selection button 5- M1 Memory button 6- M2 Memory button 7- Normal drive height button 8- Lifting button 9- Lowering button 10- Stopping button 11- Lifted axle selection button

- 120 -