H476-USER MANUAL-FULL BOOK-ENGLISH

SAFETY

2

Park Brake Control

Park brake is placed on the front console. Always apply the park brake after parking the vehicle. Chock the tires if the vehicle is parked on a slope. Park position

Then, bring the lever to park position (position 1) again. • Then, get off the vehicle and apply the trailer park brake. Drive position:

WARNING Park brake is spring type. If there is not enough pressure in the air tanks, park brake will not be released from the control lever. There shall be enough air pressure on the tanks to release the brake. If there is not enough pressure, the brake can be release by turning the setting mechanism of the adjustment bolt located on the park brake bellows. Before releasing the park brake spring, ensure the safety of your vehicle by chocking the wheels. Do not drive the vehicle if any park brake circuits are not working. Bellows may be frozen if the brakes cannot be released while the lever is released on winter. Spring is shrunk by rotating the bellows installation bolt in the tightening direction. To ensure that the emergency spring is fully installed, installation bolt shall be tightened until it does not turn anymore.

Bring the park brake lever to 2 position.

Bring the park brake lever to 1 position. Red P illuminates on the indicator when the park brake is applied. • TEST POSITION:(TRACTOR VEHICLES) After taking lever to position 1, check whether the vehicle with semi-trailer moves by pressing on the lever and pulling the lever down (position 3).

WARNING Do not apply the park brake while the brake drums or disks are very hot, wait for them to cool.

- 9 -