H476-USER MANUAL-FULL BOOK-ENGLISH

MAINTENANCE AND SERVICE

Attaching and Detaching a Trailer

Slot

2. There is a rubber brace description label affixed on the front face of the coupling (See Fig.6). Position No.; 1 and 2 can be seen on the label. Position No.1 indicates the position of the rubber brace when the coupling is open and Position No.2 indicates the position of the rubber brace when the coupling is closed. 3. If the brace is not installed under the plastic cover on the right hand side of the coupling, it shall be installed again. Remove the plastic cover on the right hand side of the coupling for this purpose (See Fig.6 and Fig.7) 4. Engage the holed area of the rubber brace to the pin under the cover and push the rubber brace down to the end of the pin (See Fig.7). 5. Install the plastic cover back (See Fig.7, Position No.1)

Handle

Hole area

Figure-5

5

Figure-7 6. Perform the automatic locking of the trailer drawing eye and the coupling while the rubber brace is installed under the plastic plug. Small pin on the side of the locked coupling enters its seat after locking. A visual inspection shall be performed. Additionally, the larger pin that enter the drawing eye of the coupling shall be visually inspected, too (See Fig.7)

Figure-6 Connecting the coupling - For Coupling with VBG 8500 Brand 1. Rubber brace of the coupling is delivered as installed under a plastic cover on the right-hand side of the coupling ex factory as shown in Fig.7.

- 152 -

Made with FlippingBook - Online Brochure Maker