H476-USER MANUAL-FULL BOOK-ENGLISH

MAINTENANCE AND SERVICE

Engine

Inspection and Cleaning of the Flyscreen

You can do the following with Two Buttons: • Engine Starting • Engine speed increase • Engine speed reducement • Motor shutdown The SystemOperation Principle is specified below: The Function consists of 4 basic conditions; 1. When the ignition is in position 2, by pressing the Start button, the engine is engaged. 2. When the engine is engaged, the first long pressing the Start button will increase the engine torque. When the button is released, the engine torque is stabilized at the level. 3. First long press after increasing the engine speed reduces the speed, and it is kept constant at the point where the button is released. 4. Stop button is only used to halt the engine that is engaged. In any event, when Stop button is pressed the engine halts.

it would be possible to prevent the deformations on the cooling module that may be caused by the flyscreen springs. CAUTION Dirty flyscreen prevents air flow to the intercooler, thus to the radiator, and reduces the cooling capacity of the engine. Therefore, the cleaning procedure described above is important. Engine Start/Stop buttons Engine • Operation Conditions • The ignition shall be at position '2'. • The cab shall be overturned • Doors must be closed • Parking brake must be applied • Vehicle speed must be "0". WARNING Note: In an event where one of these conditions are not met, the engine will not be engaged with Start Button.

5

Flyscreen, placed in front of the radiator, is a component that resembles a curtain and it can be cleaned. Its purpose is to prevent objects such as flies, dust, bugs etc.from entering directly to the radiator. Inspect the Flyscreen as per the working conditions and clean it if it is dirty. Cleaning is performed by removing the flyscreen from the radiator and applying pressurized water or air to the flyscreen. Removal of the flyscreen: Pull the flyscreen lower bar downwards from its sides and take it out of the lower seats that connect it to the cooling module. Then, open the upper cover, remove the flyscreen upper connection springs and take it out by pulling it upwards from this area. In this way,

1-Start 2-Stop

- 185 -