H476-USER MANUAL-FULL BOOK-ENGLISH

MAINTENANCE AND SERVICE

Electrical Systems

Connecting the battery terminals

Checking the electrolyte level

Open the upper connection profile of the step bracket under the battery cover in the direction of the arrow.

CAUTION Remove the key from the ignition switch. Turn off all consumers. Connect the positive terminals. Do not confuse terminals! • Connect the negative terminals. • Fit the battery cover. Perform the following when the power is disconnected (e.g.when the terminals are disconnected and connected again). • Set the clock.

5

CAUTION Battery box is white colored to provide the visibility of the liquid from outside. Pay attention to min./max. sign to understand whether the liquid level is adequate or not. Check the electrolyte level every six months or 40.000 km. Tap water decreases battery power. Only add demineralized or distilled water. Do not use a metal hone when you are filling the batteries. There is a risk of short circuit. • Open the battery housing cover and remove it. • Remove the plugs. • Check the electrolyte level and correct if required.

Then pull the battery cover to yourself in the arrow direction and remove easily. After the battery replacement; if the replacement is made outside authorized service and parameter update is not performed, “replacement notification” signal is sent for 10 seconds. In this case, the hazard lights button must be pressed 7 times within 14 seconds while the ignition is on.

Removing the battery cover

- 192 -