H476-USER MANUAL-FULL BOOK-ENGLISH

MAINTENANCE AND SERVICE

Electrical Systems

• Install the plugs. • Fit the battery cover.

of the vehicle battery, and negative (-) terminal of the spare battery to the negative terminal of the vehicle battery. - Start the engine. Run the engine under 1000 rpm. - Disconnect the negative jumper cable from the spare battery first, and then the vehicle battery. Disconnect the positive cable in the same way. - If two vehicles are used, make sure that their bodies or frames do not contact each other. - Do not approach the batteries with sparks or naked flames as the hydrogen will always be available. - Connect the jumper cables as specified above to prevent sparks in the vicinity of the batteries. Always use booster cables with insulated clamps and adequate size cable. Do not disconnect the battery from the vehicle’s electrical system. To start the engine: a- Run the engine of the vehicle with charged battery with a high speed. b- Start the engine of the vehicle with the flat battery. c- Run both vehicles for a minimum of three minutes before disconnecting the Otherwise, you may damage electronic equipment like the engine electronic control unit or the digital instrument cluster.

WARNING Batteries are very heavy. You may drop the battery and injure yourself or others when you are removing or installing a battery. Thus, be careful when you are removing the battery and use the help of a second technician. WARNING Make sure that the battery housing cover is closed. Ensure that the battery surface is always clean. WARNING There is a risk of explosion because of the forming of explosive gases. Avoid sparks! Do not work with open fires or lights near batteries. Do not smoke.

Battery Info

5

The blink of the battery status indicator shows that the battery charging level is very low. The best method in this condition is to keep the engine on immediately for batteries to be able to charged Using Jumper Cables If your battery is discharged and you want to start your engine with jumper cables, read the following instructions carefully to prevent damage to the charge system. - The voltage of the spare battery (batteries) should be the same with your battery (your vehicle has a 24V electrical system). Keep the spare batteries in a well-ventilated environment. - Turn off all other consumers. Connect the jumper cables to the spare battery first. Connect the positive (+) terminal of the spare battery to the positive terminal

- 193 -

Made with FlippingBook - Online Brochure Maker