H476-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

Opening and closing of the vehicle

Opening the Windowwith Remote Control Doors are unlocked and windows are lowered to the minimum level when opening button on the remote control is pressed for more than 3 seconds. This feature also includes the opening of sunroof with the windows on vehicles with power roof. Closing the Windowwith Remote Control Doors are locked and windows are closed automatically when closing button on the remote control is pressed for more than 3 seconds. This feature also includes the closing of sunroof after the doors on vehicles with power roof. Window closing operation is not performed if the “Quick Window Closing” feature is not set on the windows.

WARNING New remote controls shall be introduced to the vehicle when a new control is purchased. Please visit a Ford authorized dealer for the introduction of the controls. Doors are locked again if the central lock is opened with remote control and doors are not opened physically. Doors are locked automatically when vehicle speed exceeds 10 km/h. WARNING Module switches to protection mode if opening and closing operation is performed successively for 8 times in central locks both manually and via the remote control. System stops manual operation and operations by the control for 7 seconds. It performs the operations received after those 7 seconds later. This condition ends if you wait for 1 minute without any intervention.

4

Doors are locked automatically when the speed of your vehicle exceeds 10 km/h. You may deactivate this feature if required. To do this, reading lamp button shall turned on and off 8 times within 10 seconds when the door is open and ignition is at position 2. Reading lamps shall flash 4 times if the operation is successful. Automatic locking feature when the vehicle speed exceeds 10 km/h is deactivated after this procedure. Perform the same procedure while doors are closed to reactivate the automatic locking feature. Note: Wait for 10 seconds if the procedure fails and then try the procedure chain.

- 50 -