H476-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

Driving

Before taking off:

Starting the engine

CAUTION Wait for the period determined by the electronic control unit (10 to 40 seconds) before starting again after a start failure. Do not attempt to start in this period. Cold Start • Turn the ignition on. (position ). Cold starting lamp will be continuously on • Start the engine (position the cold start lamp turns off, • We advise you to apply the clutch pedal to lower the load on the engine. • If the engine does not start, switch the ignition off, wait for 1 minute and repeat the steps above. ) when

4

Check the air pressures on the brake circuits.

Turn the ignition on. • Turn the ignition switch to position Wait until the engine warning lamp is turned off. refer to maintenance and service chapter MIL lamp • When gear idle, (press clutch for manuel transmission vehicles) and. Start the engine by turning the ignition switch to position (max.10 seconds) • Wait for 15 seconds if the engine does not start and repeat the same procedure in the same order.

- 91 -