Lincoln-MKT-Owner-Manual

Lighting

• Tap the top or bottom of the control to brighten or dim all interior lit components incrementally. • Press and hold at the first position the top or bottom of the control until you reach the desired lighting level. • Press and hold the top of the control to the full on position to activate the “dome on” feature. This turns on the interior courtesy lights. The lights remain on until you press the bottom of the control. HEADLAMP EXIT DELAY Set the delay time to keep the headlamps on for up to three minutes after switching off the ignition. Follow the steps below to change the delay time: Note: Complete steps 1 through 6 within 10 seconds. 1. Switch the ignition off. 2. Select the autolamp position on the lighting control.

3. Switch the lighting control to the off position.

DAYTIME RUNNING LAMPS (If Equipped)

4. Switch the ignition on. 5. Switch the ignition off.

WARNING The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions. Make sure you switch the headlamps on, as appropriate, during all low visibility conditions. Failure to do so may result in a crash. The system turns the lamps on in daylight conditions. To switch the system on, switch the lighting control to the off, autolamp or parking lamp position.

6. Select the autolamp position on the lighting control. The headlamps and parking lamps turn on. 7. Switch the lighting control to the off position when reaching the required delay time. The headlamps and parking lamps turn off. Set the headlamp exit delay to one of the following settings: • Off. • 10 seconds. • 20 seconds. • 120 seconds. Note: Adjust the time delay using the display controls in the information display. See Information Displays (page 109).

93

MKT (TP4) , enUSA, Edition date: 201703, First Printing