F-MAX-USER MANUAL-FULL BOOK-ENGLISH

OPERATION

Driving

Before taking off

Starting the engine

CAUTION Wait for the period determined by the electronic control unit (10 to 60 seconds) before starting again after a start failure. Do not attempt to start in this period. Cold Starting of the Engine Turn the ignition on. (position 2 ) cold starting lamp shall be continuously on. • Start the engine (position 3 ) when the cold start lamp turns off, • If the engine does not start, switch the ignition off, wait for 10 minute and repeat the steps above.

3

4

2

1

Check the air pressures on the brake circuits. CAUTION Visual and audible warnings are displayed on the screen when brake air level is low in the vehicle. Do not bring the parking brake to drive position and attempt to drive the vehicle before the stopping of the visual warning and the buzzer.

0

Turn the ignition on. • Bring the ignition switch to position 2 . Wait until the engine warning lamp is turned off. Refer to maintenance and service chapter MIL lamp. • Switch the engine on by turning the ignition switch to 3 position while the gear is at neutral. (allowed for max. 15 seconds) • Wait for 15 seconds if the engine does not start and repeat the same procedure in the same order.

- 102 -